Omnibus F4 Nano V6 Flight Controller

Omnibus F4 Nano V6 Flight Controller
Made By: Airbot
Item No.: AB80100

Product Overview:
5x UARTs
Support ESC Telemetry function on 4in1 Socket
5V/2A BEC
2-6S LiPO power
Firmware, please use Fireworks v2, but in CLI, set gyro_to_use = SECOND
Airbots new V6 brushless AIO flight controller for FPV may be small but is packed with features.
With Support ending for F1 processors, F3 become the bottom wrung, but don't worry, this little board features an F4 MCU.
Its Betaflight OSD is connected over SPI in DMA, and is designed on the current proposed architecture for betaflight.
It will show you any and all data you want on your FPV feed and you can change settings including tune your PIDs without taking your goggles off!
The board also features an MPU6000 gyro connected over SPI for fast, accurate, low noise gyro data and can support 2-6s direct input.

Notice:
If you plan to use the FC with our 4in1 ESC(Wave or Ori 4in1), you only need one 8pin Cable (The Optional 8pin 4in1 Cable)


FEATURES:
01. 2-6s direct input (adaptor to connect to Wave 4in1 ESC providing power and ESC signal connection (note Wave is 2-4s))
02. MPU6000 gyro connected by SPI for low noise, clean, high frequency gyro samples
03. BMP280 Barrometer to enable altitude hold
04. Betaflight OSD
05. Onboard voltage sensor
06. On board 5v regulator, components rated to 2A - recomended 1A max to prevent heat build up)
07. Built in L-C filter to provide clean power to FPV kit
08. STM32 F405 MCU running betaflight 3.2
09. pin headers for SBUS/PPM input
10. output for 4 motors on JST-SH 1.0 8pin plug connects to Airbot Wave 4in1 ESC (The Option 8pin 4in1 Cable)
11. Size 25x25mm (20x20mm M3 mount holes)


Package Content:
1x Omnibus F4 Nano V6 Flight Controller